System Sensor SP2 Series Wall Speaker_Strobes - Manual (Page 3)

D690-01-00 3 I56-1368-005R
Mounting
Reversible strobe module
Should the back box be located near an obstruction such as
a doorway, the strobe module is field-reversible (Fig. 3).
To reverse the strobe module: insert screwdriver, as shown
in Fig. 3, to unlock snap. While pushing in the screwdriv-
er, pull back on the strobe module. Hinge the strobe mod-
ule, disengage the Locking Rib and lift the module away
from the mounting plate. Turn the module so that it is
upside down from its original position, re-insert the mod-
ule into the mounting plate (be sure to insert the Locking
Rib into the slot), and press the module into the mounting
plate. The strobe module will make a “click” when it has
locked into place. Turn the entire assembly so that the word
“FIRE” is right side up. The unit can now be mounted.
Flush mount back box
The speaker/strobe can be flush mounted on a 4″ Ч 4″ Ч
2
1 /
8
″ back box (Fig. 4) as follows:
A. Select the appropriate pair of diagonally opposite
mounting holes in the speaker grille that will be used to
attach the speaker/strobe to the back box. Do not insert
any mounting screws at this point.
B. Plug the two holes that will not be used for attachment,
using two 8-32 × 1 3 /
4
″ pan head screws and hex-nuts pro-
vided.
C. Use the two remaining 8-32 × 1 3 /
4
″ pan head screws to
attach the speaker to the back box.
NOTE: Two drywall screws (provided) may be used to fas-
ten the mounting plate to the wall. To use the dry-
wall screws, it will be necessary to first loosen the
strobe screw and hinge the strobe module away
from the mounting plate.
Surface mount with BBS-SP2 back box skirt
An optional back box skirt is available to provide a finished
appearance. Mount the skirt to the back box using the mount-
ing screws provided with the speaker/strobe as follows:
A. Select the appropriate pair of diagonally opposite
mounting holes in the speaker grille that will be used to
attach the speaker/strobe to the back box. Do not insert
any mounting screws at this point.
B. Plug the two holes that will not be used for attachment,
using two 8-32 × 1 3 /
4
″ pan head screws and hex nuts pro-
vided.
C. Use the two remaining 8-32 × 1 3 /
4
″ pan head screws to
attach the speaker to the back box.
NOTE: Two drywall screws (provided) may be used to fas-
ten the BBS-SP2 to the wall.
NOTE: The back box or back box with extension ring com-
bination must be 4″ × 4″ and a minimum of 2 1 /
8
″
deep if using a BBS-SP2.
NOTE: To surface mount the SP2 series speaker/strobe,
the minimum depth required in the back
box/extension ring combination, is 2
5 /
8
″.
Figure 4: Flush mount back box
Figure 5: Surface mount with SP2-BBS back box skirt
Figure 3: Reversible strobe module
Figure 6: Mounting to irregular surfaces
INSERT SCREWDRIVER
TO REMOVE
LOCKING RIB
A78-2680-00
4-INCH BACK BOX
A78-2679-00
4-INCH BACK BOX
DRYWALL SCREWS
(OPTIONAL)
BBS-SP2
A78-2678-00
DRYWALL
SCREWS
(OPTIONAL)
LOCKING RIB SLOT
A78-2681-00