System Sensor SP2R1224MC and SP2W1224MC - Manual (Page 4)

D900-29-00 4 I56-1809-009R
©2006 System Sensor
System Sensor warrants its enclosed product to be free from defects in materi-
als and workmanship under normal use and service for a period of three years
from date of manufacture. System Sensor makes no other express warranty for
this air duct smoke detector. No agent, representative, dealer, or employee of
the Company has the authority to increase or alter the obligations or limitations
of this Warranty. The Company’s obligation of this Warranty shall be limited
to the replacement of any part of the product which is found to be defective
in materials or workmanship under normal use and service during the three
year period commencing with the date of manufacture. After phoning System
Sensor’s toll free number 800-SENSOR2 (736-7672) for a Return Authorization
number, send defective units postage prepaid to: System Sensor, Returns
SpectrAlert Speaker/Strobes have been tested and found to comply with the limits for a
Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed
to provide reasonable protection against harmful interference when the equipment
is operated in a commercial environment. This equipment generates, uses, and can
If either of the voltage select or power select shunts is not plugged into one of the
appropriate option positions, the speaker will not sound and there will be no trouble
indication at the panel. Always make sure that the individual speakers are tested after
installation per NFPA regulations.
The speaker may not be heard. The loudness of the speaker meets (or exceeds) the
current Underwriters Laboratories’ standards. However, the speaker may not attract
the attention of a sound sleeper or one who has recently used drugs or has been
drinking alcoholic beverages. The speaker may not be heard if it is placed on a dif-
ferent floor from the person in hazard or if placed too far away to be heard over the
ambient noise. Traffic, air conditioners, machinery, or music appliances may prevent
even alert persons from hearing the alarm. The speaker may not be heard by persons
who are hearing impaired.
WARNING
The Limitations of Speaker/Strobes
The signal strobe may not be seen. The electronic visual warning signal uses an
extremely reliable xenon flash tube. It flashes at least once every second. The strobe
must not be installed in direct sunlight or areas of high light intensity (over 60 foot
candles) where the visual flash might be disregarded or not seen. The strobe may not
be seen by the visually impaired.
The signal strobe may cause seizures. Individuals who have positive photoic re-
sponse to visual stimuli with seizures, such as persons with epilepsy, should avoid
prolonged exposure to environments in which strobe signals, including this strobe,
are activated.
The signal strobe cannot operate from coded power supplies. Coded power sup-
plies produce interrupted power. The strobe must have an uninterrupted source of
power in order to operate correctly. System Sensor recommends that the horn and
signal strobe always be used in combination so that the risks from any of the above
limitations are minimized.
Please refer to insert for the Limitations of Fire Alarm Systems
Surface mount with BBS-SP2 back box skirt
An optional back box skirt is available to provide a finished
appearance. Mount the skirt to the back box using the mount-
ing screws provided with the speaker/strobe as follows:
A. Use the two 8-32 × 1
3 /
4
˝ pan head screws to attach the
speaker to the back box.
B. Plug the two holes that will not be used for attachment,
using plugs provided.
NOTE: Two drywall screws (provided) may be used to fas-
ten the BBS-SP2 to the wall.
NOTE: The back box or back box with extension ring com-
bination must be 4˝×4˝ and a minimum of 2
1 /
8
˝ deep if
using a BBS-SP2.
NOTE: To surface mount the SP2 series speaker/strobe,
the minimum depth required in the back box/extension
ring combination, is 2
5 /
8
˝.
Figure 6: Surface mount with SP2-BBS back box skirt
Figure 7: Mounting to irregular surfaces
4-INCH BACK BOX
DRYWALL SCREWS
(OPTIONAL)
BBS-SP2
A0107-00
DRYWALL
SCREWS
(OPTIONAL)
LOCKING RIB SLOT
A0108-00
FCC Statement
radiate radio frequency energy and, if not installed and used in accordance with the in-
struction manual, may cause harmful interference to radio communications. operation
of this equipment in a residential area is likely to cause harmful interference in which
case the user will be required to correct the interference at his own expense.
Department, RA #__________, 3825 Ohio Avenue, St. Charles, IL 60174. Please
include a note describing the malfunction and suspected cause of failure.
The Company shall not be obligated to replace units which are found to be
defective because of damage, unreasonable use, modifications, or alterations
occurring after the date of manufacture. In no case shall the Company be
liable for any consequential or incidental damages for breach of this or any
other Warranty, expressed or implied whatsoever, even if the loss or damage
is caused by the Company’s negligence or fault. Some states do not allow the
exclusion or limitation of incidental or consequential damages, so the above
limitation or exclusion may not apply to you. This Warranty gives you specific
legal rights, and you may also have other rights which vary from state to state.
Three-Year Limited Warranty