System Sensor SS1224ADA and MASS1224ADA Series - Manual (Page 4)

D900-01-00 4 I56-650-17
© System Sensor 1997
A78-2514-00 A78-2515-00
A78-2516-00
A78-1137-08
C
F
F
C
MP-F
MA 12/24D
D
D
BB-D
A
A
B
B
G
G
MA 12/24
MP-SF
Plaster
Ring
Standard
Backbox
A78-1137-11
A78-2517-01
1. Complete field wiring.
2. Screw strobe to box with screw A.
3. Fill remaining holes with screw B. 1. Complete field wiring.
2. Screw sounder/strobe to box with screw A.
3. Fill remaining screw holes with screw B
1. Screw plate to box with screw E.
2. Complete field wiring. (See Fig. 3, 4, 5, and 6)
3. Screw sounder or sounder/strobe
to plate with screw A.
4. Fill remaining holes with screw B.
1. Screw strobe to plate with
screw C.
2. Complete field wiring.
3. Screw strobe plate to box with
screw A.
1. Screw sounder to plate.
2. Complete field wiring.
3. Screw plate sounder to box
with screw F.
1. Plaster ring should be properly mounted to electrical box with
screws supplied with box.
2. Screw plate to plaster ring with screw G.
3. Complete field wiring.
4. Screw sounder/strobe to plate with screw A.
5. Fill remaining holes with screw B.
B
A
A B
Signal Strobe
Standard
Backbox
TOP
MA-12/24D
A
B
B
A
Signal Strobe
Standard
Backbox
Figure 8. Strobe surface mount: Figure 9. Sounder/strobe surface mount:
MP-SF
MA-12/24D
B
B
STANDARD
BACKBOX
A
A
E
E
Figure 10. Sounder or sounder/strobe semi-flush
mount:
MP-SF
Signal Strobe
TOP
STANDARD
BACKBOX
C
C
A
A
Figure 11. Strobe semi-flush mount:
Figure 12. Sounder flush mount (deep box required): Figure 13. Sounder or sounder/strobe semi-flush
mount with plaster ring: