System Sensor RA400Z and RA400ZA - Manual (Page 2)

BEND TAB DOWN
TO BREAK
FOR USE WITH MOST
INTELLIGENT SYSTEMS.
D220-01-00 2 I56-508-05
© 2004 System Sensor
THE REMOTE ANNUNCIATOR WILL NOT WORK IF THE DEVICE IT IS
CONNECTED TO IS NOT POWERED. The remote annunciator gets its
power from the device to which it is connected. If for any reason, the
device being monitored loses power, the remote annunciator will not pro-
vide the intended visible signal.
THE REMOTE ANNUNCIATOR MAY NOT BE SEEN. The model RA400Z is
suitable for direct viewing and is in compliance with existing Underwriters
Laboratories’ standards. The device must be sited in a location where it
can be seen by the intended parties. The device must not be installed in
WARNING
The Limitations of Remote Annunciators
direct sunlight, or areas of high light intensity where the visible signal
might be disregarded or not seen.
THIS DEVICE IS DESIGNED TO WORK SPECIFICALLY WITH SYSTEM
SENSOR PRODUCTS. Interconnection with devices other than System
Sensor’s may result in unsatisfactory operation. Consult device manufac-
turer for compatibility.
THE REMOTE ANNUNCIATOR IS NOT INTENDED TO BE A VISIBLE
WARNING SIGNAL.
H0356-00
Figure 1:
H0354-00
From
Monitored
Device
Figure 2:
(See Note 1)