System Sensor PS12_24SLENSC - Manual

D900-15-00 1 I56-1000-01
© 2002 System Sensor
Smoke Strobe Lens
INSTALLATION AND MAINTENANCE INSTRUCTIONS
3825 Ohio Avenue, St. Charles, Illinois 60174
1-800-SENSOR2, FAX: 630-377-6495
www.systemsensor.com
NOTICE: This manual should be left with the owner/user
of this equipment.
General Information
The National Fire Protection Association has published
codes, standards, and recommended practices for the
installation and use of this product. It is recommended that
the installer be familiar with these requirements, with local
codes, and any special requirements of the local authority
having jurisdiction.
This SMOKE strobe lens is designed to replace the FIRE
lens used with the PS12 and PS24 strobes.
NOTE: To install the SMOKE lens, a PS12 or PS24 strobe
accessory must be purchased separately.
Mounting
Remove the two screws on the back of the PS12 or PS24
assembly (see Figure 2). The FIRE lens can now be removed.
Reverse this procedure to install the SMOKE lens.
Please follow the installation instructions (I56-305-07)
included with the PS12 and PS24 accessory to complete
the installation.
Model Numbers
SMOKE lens, wall mount
PS12/24-LENS-SW
SMOKE lens, ceiling mount PS12/24-LENS-SC
Figure 1. SMOKE lens:
Figure 2. Remove the rear screws:
System Sensor warrants its enclosed SMOKE lens to be free from defects
in materials and workmanship under normal use and service for a period
of three years from date of manufacture. System Sensor makes no other
express warranty for this SMOKE lens. No agent, representative, dealer,
or employee of the Company has the authority to increase or alter the
obligations or limitations of this Warranty. The Company’s obligation of
this Warranty shall be limited to the repair or replacement of any part of
the SMOKE lens which is found to be defective in materials or workman-
ship under normal use and service during the three year period com-
mencing with the date of manufacture. After phoning System Sensor’s
toll free number 800-SENSOR2 (736-7672) for a Return Authorization
number, send defective units postage prepaid to: System Sensor, Returns
Red Leg
Three-Year Limited Warranty
Department, RA #__________, 3825 Ohio Avenue, St. Charles, IL 60174.
Please include a note describing the malfunction and suspected cause
of failure. The Company shall not be obligated to repair or replace units
which are found to be defective because of damage, unreasonable use,
modifications, or alterations occurring after the date of manufacture. In
no case shall the Company be liable for any consequential or incidental
damages for breach of this or any other Warranty, expressed or implied
whatsoever, even if the loss or damage is caused by the Company’s neg-
ligence or fault. Some states do not allow the exclusion or limitation of
incidental or consequential damages, so the above limitation or exclusion
may not apply to you. This Warranty gives you specific legal rights, and
you may also have other rights which vary from state to state.
I56-1000-01