System Sensor 2112_24S and 2112_24TS Photoelectric User Manual

Page 4

Advertising

D200-62-00

I56-932-12R

2001 System Sensor

Three-Year Limited Warranty

System Sensor warrants its enclosed smoke detector to be free from de-
fects in materials and workmanship under normal use and service for a
period of three years from date of manufacture. System Sensor makes no
other express warranty for this smoke detector. No agent, representative,
dealer, or employee of the Company has the authority to increase or alter
the obligations or limitations of this Warranty. The Company’s obligation
of this Warranty shall be limited to the repair or replacement of any part of
the smoke detector which is found to be defective in materials or work-
manship under normal use and service during the three year period com-
mencing with the date of manufacture. After phoning System Sensor’s toll
free number 800-SENSOR2 (736-7672) for a Return Authorization number,
send defective units postage prepaid to: System Sensor, Repair Depart-

ment, RA #__________, 3825 Ohio Avenue, St. Charles, IL 60174. Please
include a note describing the malfunction and suspected cause of failure.
The Company shall not be obligated to repair or replace units which are
found to be defective because of damage, unreasonable use, modifica-
tions, or alterations occurring after the date of manufacture. In no case
shall the Company be liable for any consequential or incidental damages
for breach of this or any other Warranty, expressed or implied whatsoever,
even if the loss or damage is caused by the Company’s negligence or fault.
Some states do not allow the exclusion or limitation of incidental or conse-
quential damages, so the above limitation or exclusion may not apply to
you. This Warranty gives you specific legal rights, and you may also have
other rights which vary from state to state.

A78-2565-07

Figure 5. Removal of cover and screen for cleaning:

1. Remove cover by turning counter clockwise in direction

of arrow.

2. Vacuum the cover carefully (See Figure 5).
3. Remove the sensing chamber cover.
4. Clean the sensing chamber by vacuuming or blow

ing out dust and particles.

5. Replace the sensing chamber cover, aligning the arrow on the

top of the chamber cover with the arrow on the housing.

6. Replace the cover by placing over the sensing chamber

cover and twisting until it snaps into place.

7. Reinstall the detector.
8. Notify the proper authorities that the system is back in

operation.

REMOVABLE
SCREEN/COVER
(PART NO. C58-357-XX))

SENSING
CHAMBER COVER

HOUSING

;;;;;;;;;;;;;

yyyyyyyyyyyyy

;;;;;;;;;;;;;;

yyyyyyyyyyyyyy

;

Please refer to insert for the Limitations of Fire Alarm Systems

Advertising

Popular Brands

Popular manuals