System Sensor M500R - Manual (Page 2)

(+)
(–)
(+)
(–)
(+)
(–)
RELAY COMMON 1
RELAY COMMON 2
NORMALLY CLOSED 1
NORMALLY OPEN 2
NORMALLY CLOSED 2
NORMALLY OPEN 1
UNUSED
SIGNAL LINE CIRCUIT (SLC)
32 VDC MAX.
TWISTED PAIR
IS RECOMMENDED
IF ANY WIRING TO TERMINALS 4 -10 IS NONPOWER
LIMITED, THE CB500 BARRIER IS REQUIRED. THE
CB500 INCLUDES A NONPOWER LIMITED LABEL,
WHICH MUST BE PLACED OVER THE POWER LIMITED
TERMINAL INFORMATION ON THE NAMEPLATE LABEL.
CONNECT MODULES TO LISTED COMPATIBLE
CONTROL PANELS ONLY
FROM
PANEL OR
PREVIOUS
DEVICE
CONTROL
MODULE
TO NEXT
DEVICE
MODULE DOES NOT SUPERVISE
CONTROLLED CIRCUITS
*NOTE: ANY FAULT IN THE POWER SUPPLY IS
LIMITED TO THAT ZONE AND DOES NOT RESULT IN
A FAULT IN A SEPARATE ZONE.
SS-460-002 2 I56-3852-003
©2011 System Sensor
ThREE-yEAR LIMITED WARRANTy
System Sensor warrants its enclosed product to be free from defects in materials and
workmanship under normal use and service for a period of three years from date of
manufacture. System Sensor makes no other express warranty for the enclosed product.
No agent, representative, dealer, or employee of the Company has the authority to in-
crease or alter the obligations or limitations of this Warranty. The Company’s obligation
of this Warranty shall be limited to the replacement of any part of the product which
is found to be defective in materials or workmanship under normal use and service
during the three year period commencing with the date of manufacture. After phoning
System Sensor’s toll free number 800-SENSOR2 (736-7672) for a Return Authorization
number, send defective units postage prepaid to: System Sensor, Returns Department, RA #__________, 3825 Ohio Avenue, St. Charles, IL 60174. Please include a note describing
the malfunction and suspected cause of failure. The Company shall not be obligated to
replace units which are found to be defective because of damage, unreasonable use,
modifications, or alterations occurring after the date of manufacture. In no case shall the
Company be liable for any consequential or incidental damages for breach of this or any
other Warranty, expressed or implied whatsoever, even if the loss or damage is caused by
the Company’s negligence or fault. Some states do not allow the exclusion or limitation of
incidental or consequential damages, so the above limitation or exclusion may not apply
to you. This Warranty gives you specific legal rights, and you may also have other rights
which vary from state to state.
fIgURE 3. RELAy MODULE WIRINg DIAgRAM:
C0924-03
WARNING
All relay switch contacts are shipped in the standby (open) state, but may have transferred to the activated (closed) state during shipping. To ensure that the
switch contacts are in their correct state, modules must be made to communicate with the panel before connecting circuits controlled by the module.
fIgURE 2A. MODULE MOUNTINg WITh BARRIER:
C0927-01
fIgURE 2B:
C0926-01
ISOLATED
QUADRANT
fIgURE 1. CONTROLS AND INDICATORS:
C0925-01