AMD Geode LX 800@0.9W - Manual (Page 406)

406 AMD Geode™ LX Processors Data Book
Video Processor 33234H
6.7.7.3 FP Functional Description
The FP connects to the RGB port of the video mixer.
LCD Interface
The FP interfaces directly to industry standard 18-bit or 24-
bit active matrix thin-film-transistor (TFT). The digital RGB
or video data that is supplied by the video logic is con-
verted into a suitable format to drive a wide variety range of
panels with variable bits. The LCD interface includes dith-
ering logic to increase the apparent number of colors dis-
played for use on panels with less than 6 bits per color. The
LCD interface also supports automatic power sequence of
panel power supplies.
Mode Selection
The FP can be configured for operation with most standard
TFT panels:
• Supports TFT panels with up to 24-bit interface with
640x480, 800x600, 1024x768, 1280x1024, and
1600x1200 pixel resolutions. Either one or two pixels per
clock is supported for all resolutions. Other resolutions
below 640x480 are also supported.
Table 6-66 shows the mapping of the data in the supported
modes.
For TFT panel support, the output from the dither block is
directly fed on to the panel data pins (DRGBx). The data
that is being sent on to the panel data pins is in sync with
the TFT timing signals such as HSYNC, VSYNC, and LDE.
One pixel (or two pixels in 2 pix/clk mode) is shifted on
every positive edge of the clock as long as DISP_ENA is
active.
Table 6-66. Panel Output Signal Mapping
Pin Name
TFT
9-Bit
TFT
18-Bit
TFT
24-Bit
TFT
9+9-Bit
TFT
12+12-Bit
DRGB0 B0 BB0
DRGB1 B1 BB0 BB1
DRGB2 B0 B2 BB1 BB2
DRGB3 B1 B3 BB2 BB3
DRGB4 B2 B4 GB0
DRGB5 B0 B3 B5 GB0 GB1
DRGB6 B1 B4 B6 GB1 GB2
DRGB7 B2 B5 B7 GB2 GB3
DRGB8 G0 RB0
DRGB9 G1 RB0 RB1
DRGB10 G0 G2 RB1 RB2
DRGB11 G1 G3 RB2 RB3
DRGB12 G2 G4 BA0
DRGB13 G0 G3 G5 BA0 BA1
DRGB14 G1 G4 G6 BA1 BA2
DRGB15 G2 G5 G7 BA2 BA3
DRGB16 R0 GA0
DRGB17 R1 GA0 GA1
DRGB18 R0 R2 GA1 GA2
DRGB19 R1 R3 GA2 GA3
DRGB20 R2 R4 RA0
DRGB21 R0 R3 R5 RA0 RA1
DRGB22 R1 R4 R6 RA1 RA2
DRGB23 R2 R5 R7 RA2 RA3