Teledyne LeCroy WaveRunner 6 Zi_HRO 6 Zi, 8-Channel Sync Instruction Manual - Manual

Instructions
WaveRunner 6 Zi / HRO 6 Zi, 8-Channel Sync
Introduction
The WR6Zi-8CH-SYNCH option for your Teledyne LeCroy WaveRunner 6 Zi or HRO 6 Zi oscilloscope ena-
bles the capture and transfer of waveforms from one oscilloscope to the other for simultaneous display,
measure, and analysis of up to eight waveforms. You can display all acquired channels on the Master for
easy viewing and analysis.
The Master serves as the source from which all simple or complex triggers are selected. Slave channels
are not available as sources for triggering. The Master is utilized for all measurements, analysis, and doc-
umentation for any and all eight channels.
The Slave oscilloscope acquires data, which is then sent to the Master. All Slave channel vertical settings
are made on the Slave, not on the Master.
When the WR6Zi-8CH-SYNCH option setup is complete, the Master instrument’s Vertical pull-down menu
provides functionality for:
l
Connecting to the Slave using a manually provided IP Address
l
Displaying up to 8 waveform channels
l
Disconnecting from the Slave
The WR6Zi-8CH-SYNCH software option automatically accounts for the propagation delay (waveform
transfer times) between the Slave and the Master.
922276-00 Rev A 1