Teledyne LeCroy LogicStudio - Manual (Page 40)

LogicStudio
A
36 922294 Rev A
Safety Compliance
EC D ECLARATION O F C ONFORMITY
–
L OW V OLTAGE
The oscilloscope accessory meets intent of EC Directive 2006/95/EC for
Product Safety. Compliance was demonstrated to the following
specifications as listed in the Official Journal of the European Communities:
EN 61010-031/A1:2008 Safety requirements for electrical equipment for
measurement, control, and laboratory use – Part 031: Safety requirements
for hand-held probe assemblies for electrical measurement and test.

Measurement Category I (CAT I), for measurements performed on
circuits not directly connected to a mains supply.

Pollution Degree 2, operating environment where normally only
dry non-conductive pollution occurs. Conductivity caused by
temporary condensation should be expected.
Environmental Compliance
E
ND
-
OF
-L
IFE
H
ANDLING
The oscilloscope accessory is marked with this symbol to
indicate that it complies with the applicable European Union
requirements to Directives 2002/96/EC and 2006/66/EC on
Waste Electrical and Electronic Equipment (WEEE) and
Batteries.
The oscilloscope accessory is subject to disposal and
recycling regulations that vary by country and region. Many
countries prohibit the disposal of waste electronic
equipment in standard waste receptacles. For more information about
proper disposal and recycling of your Teledyne LeCroy product, please visit
teledynelecroy.com/recycle.
R
ESTRICTION
O
F
H
AZARDOUS
S
UBSTANCES
(R
O
HS)
This oscilloscope accessory has been classified as Industrial Monitoring and
Control Equipment, and is outside the scope of the 2011/65/EU RoHS
Directive (Exempt until July 2017, per Article 4).