Teledyne LeCroy LabMaster 10Zi Rackmount - Manual

Assembly Instructions
LabMaster 10Zi Rack Mount
Thank you for purchasing a Teledyne LeCroy LabMaster 10Zi Rack Mount accessory. The following procedures explain proper
installation of the rack mount.
CAUTION. The LabMaster 10Zi system performance depends on adequate airflow into the vents on the bottom cover of
the units. When installing in a rack, do not position the units so as to block the vents. Any equipment or debris in the 1
inch (25.4 mm) space below the units could result in performance degradation and possible shutdown of the system.
Upon receiving your shipment, remove all parts from the packaging. Refer to the Parts Table to ensure that all items have shipped
correctly, and contact us immediately if any parts are missing.
Use the provided tools to complete the assembly.
T10 Torx Driver
2.5mm T-handled,
9" long Allen Key
T25 T-handled Torx Driver
MCMZi Control Module
Pre-Assemble Brackets
Pre-assemble the brackets and handles into a single piece using two 8-32 Undercut Flat Head screws per bracket, as shown below.
Right Bracket with 3/8 Offset Handle Left Bracket with 3/8 Offset Handle
923719-00 Rev A December, 2013