Teledyne LeCroy LabMaster 10Zi Operators Manual - Manual (Page 103)

Getting Started Manual
922561-00 Rev A
95
Display Setup
To adjust the appearance of the oscilloscope display:
1. From the menu bar, touch Display → Display Setup... .
2. Touch Grid and select one of the display type buttons. The image on
each button indicates its corresponding grid configuration.
Auto Grid automatically adds or deletes grids as you select more or
fewer waveforms to display.
NOTE: Not all grid styles are available on all instruments. Grid styles vary
based on both oscilloscope model and installed options.
See “Touch Screen and External Displays” (page 25) for steps to
extend the grid display onto a second monitor.
3. To dim or brighten the grid lines, touch Grid Intensity and enter a
percentage from 0 to 100.
4. Touch the Grid on top checkbox if you want to superimpose the grid
over the waveform.
NOTE : Depending on the grid intensity, some waveforms may be hidden
when the grid is placed on top. To view them, simply uncheck Grid on top.
5. Touch the Axis labels checkbox to permanently display the values of
the top and bottom grid lines (calculated from volts/div) and the
extreme left and right grid lines (calculated from the timebase).
6. Choose a style for your trace: solid Line or Points.
7. To highlight trace samples that occur with most frequency, touch
Intensity and enter a percentage from 0 to 100. Samples occurring
less often than the intensity value are dimmed.