Teledyne LeCroy HDO 4000 Getting Started Guide - Manual (Page 35)

923010-00 Rev A
BASICS 31
Cursors
Cursors set measurement points on a trace. There are five preset cursor
types, each with a unique appearance on the display: Horizontal (Time),
Horizontal + Vertical, Vertical (Amplitude), Horizontal (Frequency), and
Horizontal (Event). These are described in more detail in the HDO4000
Oscilloscopes Operator’s Manual.
From the Front Panel
From the Display
Choose Cursor > Cursor Setup to open the Cursor dialog
Touch to choose Cursor Type.
Touch-and-drag cursor line to reposition cursor.
Vertical Cursor readout appears on descriptor boxes.
Horizontal Cursor readout appears below Timebase.
Press to apply cursor. Continue
pressing to cycle through all cursor
types.
Turn to adjust cursor position. Push
to select different cursor lines to
adjust.
A
B
A
B
A
B
C
D
E
A
B
C
D
E