Teledyne LeCroy BPT - Users Manual - Manual (Page 25)

19
CATC BPT 1.00 C HAPTER 5
User’s Manual Running Tests
When the Stop button is pressed, the Test Progress bar reads “Stopping Tests...” while the
BPT halts test execution, then changes to “Ready to Test” after test execution has stopped.
5.7 Viewing Test Results
Basic test results can viewed in the BPT application by the operator, and detailed results can
be viewed in the log file by the test engineer.
5.7.1 Basic Results
Results for each test are displayed in the numbered test columns. Possible values are:
• TEST — Indicates that the test is in progress.
• PASS — Indicates that the test completed successfully.
• FAIL — Indicates that the test did not complete successfully.
Additionally, if all the devices pass all the tests, the Test Progress bar reads “PASSED.”
However, if any device fails a test, the Test Progress bar reads “FAILED.”
The Status bar reports the number of tests that passed and failed.
5.7.2 Detailed Results
Details of the activity for each test set are written to the log file BPTlog.txt, allowing test
engineers to more closely examine the events that occurred during testing.
Example Log File
Wed 06/26/02 13:33:49 BPT end.
Wed 06/26/02 13:33:56 BPT start.
Wed 06/26/02 13:33:57 Run Mode: Normal
Wed 06/26/02 13:34:01 Test Start : 00:03:6E:10:2D:00 'Inquiry
Response Test'
Wed 06/26/02 13:34:08 Test Result: 00:03:6E:10:2D:00 'Inquiry
Response Test': Success
Wed 06/26/02 13:34:08 Test Start : 00:03:6E:10:2D:00 'Master
Connect Test'
Figure 5-7: Basic test results shown in the numbered test columns
Figure 5-8: