Teledyne LeCroy PETracer ML Analyzer and Exerciser User Manual - Manual (Page 35)

PETracer ML User Manual Chapter 3: Installation
Teledyne LeCroy
27
3.2 Setting Up a PETracer Analyzer
Step 1 Remove the Analyzer/UPAS from its shipping container. The module is
already installed in the UPAS.
Step 2 Connect the Analyzer unit to a 100-volt to 240-volt, 50 Hz to 60 Hz,
120 W power outlet using the provided power cord.
Note: The Analyzer is capable of supporting supply voltages between 100 volts
and 240 volts, 50 Hz or 60 Hz, thus supporting all known supply voltages around
the world.
Step 3 Connect the USB cable between the USB port on the back of the
Analyzer and a USB port on the host machine.
Step 4 Turn on the power switch on the rear of the UPAS.
Note: At power-on, the Analyzer initializes itself in approximately five seconds
and performs an exhaustive self-diagnostic that lasts about fifteen seconds. The
Status LED of the UPAS base unit turns red on power up/initialization. The LED
remains on approximately 20 seconds while the Analyzer performs
self-diagnostic testing. If the diagnostics fail, the Status LED blinks red, indicating
a hardware failure. If this occurs, call Teledyne LeCroy Customer Support for
assistance.
Step 5 Follow on-screen Plug-and-Play instructions for the automatic
installation of the Analyzer as a USB device on the host machine (the
required USB files are included on the CD). Step through the Windows
®
hardware wizard. If the wizard prompts you for driver information, point
it to the CD which should be in your disk drive.
The host machine’s operating system detects the Analyzer and begins to install
the USB driver.