Teledyne LeCroy AORM - Advanced Optical Recording Measurements - Manual (Page 32)

30
ISSUED: June 2013 923133 Rev A
Select a clock period by having the period
calculated from the clock source, by choosing a
standard, or by manually setting a clock period.
If you choose a clock period from a standard,
you can also set a multiplier:
Setting nT
For BES, EES, BEES, BESS, and EESS, this
specifies the pit of interest. The results will be
computed for each space/pit (pit/space) pair
using the subject pit and all the spaces within
the range specified.
Specifies the range of n indices that define the
pits/spaces used in the calculation. The range
of n coupled with T are used to categorize the
pits/spaces based on their widths.
Maximizing Performance
A basic guideline that you should follow to maximize the performance of calculation in multiple
parameter configurations is that precisely the same Value for the clock period ‘T’, Threshold level,
and Hysteresis value should be used.
Following this guideline ensures that parameters can make use of results obtained in previous
parameter calculations. However, in most cases there is no need for different configurations of
the above three items in different parameter setups.