Telexper IP Speed Dome Camera - Manual (Page 3)

2
Notice:
* For nCam Series cameras, the power is provided via
PoE by Gigabit PoE HUB. Thus, it is not necessary to
connect the DC12V In (pin-3) and GND (pin-4) (refer to
above pictures) on the camera.
* Please use the CAT-6 RJ-45 cable to connect to each
Telexper device.
* The effective distance between the PoE Hub and IP
camera is up to 100 meter.
IP CCTV Installation Diagram
Connect the
nCAM using the
CAT-6 RJ-45
cable to the PoE
hub
Connect DC 12V or AC 24V power
Power Cord
Uplink to
network