TIF 3220 Thermo-Anemometer and IR Thermometer - Manual (Page 4)

OPERATING INSTRUCTIONS (CONT’D)
POWER ON/OFF
and AUTO SHUTDOWN
1. Press the power ON/OFF button to turn the
meter ON or OFF.
2. Auto Shutdown: The meter will automatically
turn off after fifteen minutes if no keys are
pressed during this time.
3. Disable Auto Shutdown: To disable auto
shutdown function, press and hold the IRT
button as you turn the meter ON. The display
will show “disAP0”; then release the IRT
button.
NOTE: Automatic Shutdown feature is always
disabled when the unit is in “CFM/CMM” or
“AVG” mode.
MAINTENANCE
REPLACING THE BATTERY
1. The thermometer must be OFF when
changing the battery. Press to power
OFF the thermometer.
2. On the back side of the thermometer,
locate the symbol.
3. While holding the thermometer, place
your thumb on the . With gentle
pressure push downward and pull
backward; the battery cover will begin to
open. Use your other hand to grasp the
cover and pull downward. Lift the cover
up and off.
4. Lift out the 9-volt battery and disconnect
it from the connector.
5. Connect a new 9-volt battery and place it
into the battery cavity.
6. Replace the battery cover by setting it
over the battery and pushing upward until
it snaps into place.
7. Dispose of the old battery according to
local, state, and federal regulations.
Back sheet 2 of 2
Form No. 546185 Rev. A June 20, 2008 © 2008 SPX
655 Eisenhower Drive
Owatonna, MN 55060
Toll Free: (800) 327-5060
Fax: (866) 287-7222
www.TIF.com
WARRANTY
This product has been produced to provide un-
limited service. Should it become inoperable after
the user has performed the recommended main-
tenance, a no charge repair or replacement will
be made to the original purchaser. This applies to
all repairable units that have not been damaged
or tampered with. The claim must be made within
One Year of the date of purchase.