TREND ENCLS_... - Manual

ENCLS/... Enclosures Installation Instructions TG103175 Issue 1/A 1/7/96 1
Installation Instructions
ENCLS/...
Enclosures
Important: keep these instructions with the unit.
Because these instructions contain information that may be required after installation they should be kept with the unit, or in a location
where they can quickly be found.
Installation
Mount the enclosure in position
Mount the ENCLS in position. The location should provide safe
access for maintenance, and a suitable operating environment.
It is recommended that the installation should comply
with the HSE Memorandum of Guidance on Electricity
at Work Regulations 1989.
(2) Insert suitable expanding fixing (e.g. rawlbolt)
through each hole in the enclosure, into the
mounting holes, and tighten.
Fit the item into the enclosure
(3) If fitting an IQ25x controller into the enclosure
remove the DIN rail by undoing the two fixing
screws.
(4) Locate the pre-drilled mounting holes in the
enclosure’s backplate needed by the item being
mounted in the enclosure. The table lists the
types of items that can be fitted in the enclosure.
(1) Drill 4 off 12 mm holes as shown.
IQ91e IQ131+
IQ92e IQ151+
IQ93e IQ241
IQ101+ IQ250
IQ102+ IQ251
IQ111+ NETB/NETBB
(5) Insert the screws provided through the mounting
holes in the controller or NETB, into the pre-drilled
mounting holes in the enclosure’s backplate.
Note
that it may be necessary to remove the controller’s
covers to gain access to the mounting holes; this
is described in the installation instructions for
the particular controller or NETB.
Connect the item to the Display Panel, or Network Display Panel
(6) Connect the DP, or NDP in the door of an
ENCLS/FPK, or ENCLS/NDP to the controller or
NETB/.. mounted inside the enclosure. This is
described in the controller’s or NETB installation
instructions, or data sheet.
560 mm
560 mm