TREND IQ3 User Guide - Manual (Page 27)

IQ3 Web User Guide TC200631 Issue 2, 02/02/2009 27
Using IQ3 from a Web browser
4.3.5.4 Set up an Exception’s Parameters
The exception’s parameters must be defined to specify when the exception is to occur, whether it is to be repeated
every year, and its priority. This is only possible if you have the appropriate level of authority.
to set up an exception’s parameters:
View the exceptions as described in the ‘ 1. View exceptions ’ section of this manual.
Enter a label for the exception in the left most box. 2.
In the 3. start day box click the day the exception times are to be first used.
In the 4. start Month box click the month the exception times are to be first used.
In the 5. stop day box click the last day the exception times are to be used.
In the 6. stop Month box click the month for the exception is to end.
In the 7. Priority box click the priority for the exception.
The priority parameter is used when two exceptions happen on the same day. The exception priority with the
lower value will take precedence. E.g. priority of 1 takes precedence over 3. If there are exceptions with the
same priority the exception that starts earliest takes precedence.
In the 8. use box click the required option to specify whether the exception is to occur once, is to be repeated
each year, or is unused by selecting the required option from the list. every cause the exception to be repeated
each year, next causes it to occur only once, and Free means it won’t be used.
Click 9. to send the changes to the controller.
The exceptions times must be set up separately as described in the ‘ set up an exception’s times ’ section of this
manual.