TREND PNC2 - Manual (Page 7)

2 - 3 PNC2 Printer Node Controller Installation Instructions TG200264 Issue 1/D 22/07/04
Installation Instructions - Configuration PNC2
2.1 Installation - Configuration
(continued)
10 Close panel/covers
J 7
E T 1
J 1 6
D e v B
J 1 5
D e v A
J 8
L a n A
J 1 7
11
Set up printer
Set printer RS232 serial interface as follows:
Baud rate set as step 5 above (1k2, 4k8, 9k6, or 19k2)
Comms type set as step 6 above
either 8 bits no parity
or 7 bits odd parity
Auto Line Feed: On
13 Check System
PNC2 IQ
! alarm
Lan
! alarm
PNC2
12
Configure Alarm Language
The PNC2 will automatically set its alarm language to that of the other nodes on the local Lan if possible (otherwise stays in English). It may be changed
if required:
Note that if the PNC2 is reset by power up or on change of address or baud rate, the PNC2 will automatically set its language
Recommend use of PowerTool
or Wupdn
if required
Set language by R(P=x)
where x defines language as follows:
x=0 English, =1 Spanish, =2 Finnish, =3 Swedish, =4 Norwegian, =5 Danish, =6 German, =7 Italian, =8 Portuguese, =9 French.
IQ Configuration Manual 90-1533
PNC2 Data Sheet TA200263
PowerTool Manual TE200163
Wupdn Manual TE200162