TREND IQView.._SM - Manual (Page 10)

3 - 2 IQView../SM Installation Instructions TG200711 Issue 1/E 10/08/06
IQView../SM Installation Instructions - Sheet 3
4 5 6 7
T- T+ R- R+
O
I
IQView
?
IQView
?
3.1 Installation - Configuration
(continued)
4 5 6 7
T- T+ R- R+
IQView
Check Current Loop Lan LEDs
12
if ‘Connect as Device’/’Current Loop Lan’
RX TX
OK
b TX
a RX
c OK
IQView Faulty
Check network cabling for
short circuits with a
multimeter (NOT Megger)
Check baud rate. Power
up other nodes until faulty
node is found (OK ).
Correct fault.
Network Address Invalid
0,2,3 or >119
OK
OK
(green)
(yellow)
(yellow)
Test System 14
(a) Tap on controller icon in navigator e.g. (IQ2 controller)
(b) Tap on controller menu icon e.g.
(c) Tap on ‘Modules’/’Sensors’ on drop down menus
(d) Check sensors display
Replace Covers
13
a b c d
if appropriate