Vanguard ATO-600P - Manual (Page 27)

ATO-400P / ATO-600P Operating Procedures
27
Table 6.0 Run Test Procedure (Measure an Unknown Resistance Continued)
STEP ACTION ATO DISPLAY
6-11 Pressing key #2 (NO) on SAVE THIS
TEST RECORD (see step 6-8) causes the
ARE YOU SURE? prompt to be displayed
(shown at right).
6-12 If key #1 is pressed, the test record will be
erased from the memory and the display
returns to the “START MENU”. If key #2
is pressed, the test record will be saved in
Flash EEPROM. The test record number
assigned to this record will be displayed.
Exit the RECORD SAVED display by
pressing ENTER, which returns to the
START MENU.
This ends the RUN AUTOMATIC TEST procedure.
ARE YOU SURE?
DATA WILL BE LOST!
1. DO NOT SAVE RECORD
2. SAVE RECORD
1. RUN TEST 04/11/05
2. SETUP 12:24:01
3. DIAGNOSTIC