Vanguard CT-8000 User Manual
Page 95
REV 2 CT-8000 USER’S MANUAL
90
3.7.2. Printing a Directory of Test Plans Stored in the CT-8000’s Memory
You can print a directory of all the test plans stored in the CT-8000’s Flash EEPROM using the
steps below:
a. Start from the “START-UP” menu:
Press the
[3]
key (SETUP).
b. The following screen will be displayed:
Press the
[1]
key (ANALYSIS POINTS).
c. The following screen will be displayed:
Press the
[4]
key (TEST PLANS).
d. The following screen will be displayed:
Press the
[3]
key (PRINT DIRECTORY). The test plan directory will be printed on the
built-in thermal printer and you will be returned to the “START-UP” menu. A sample test
plan directory is shown in Figure 36.
1. LOAD TEST PLAN
2. PRINT TEST PLAN
3. PRINT DIRECTORY
1. OPEN TIMING
2. CLOSE TIMING
3. PRINT SETTINGS
4. TEST PLANS
1. ANALYSIS POINTS
2. MEASUREMENT UNITS
3. SAVE / RESTORE
4. NEXT PAGE
1. RUN TEST 03/10/10
2. GET RSLT 09:04:05
3. SETUP
4. DIAGNOSTICS