Vestil FTLP-5454 - Manual (Page 7)

10/21/2010 rev. 10/22/2010 FTLP manual, operation instructions.doc
Step 3: Load the platform
The fork truck operator and bystander(s) might sustain serious personal injuries or could be killed if the
platform is misused. Disregarding obvious hazards constitutes product misuse. To reduce the likelihood of harmful
consequences:
 FTLP-series products are medium-duty rated platforms. Therefore,
ONLY use the platform with sit-down rider high lift fork trucks having
a maximum rated load of at least 3,000 pounds at a 24in. load
center.
 ALWAYS review the “Safety Guidelines” on p. 3 before each use.
 Apply ANSI/ITSDF B56.1-2005, “Safety Standard for Low Lift and
High Lift Trucks,” suggestions regarding the use of fork-mounted
platforms. The publication is freely downloadable:
http://www.itsdf.org/pB56.asp
 When raised 4 feet (~1.2m) or higher, guard rails are required if
any person must occupy the platform to load/unload equipment. Do
not lean against the handrails or safety chains. NO person should
occupy the platform during load transport. Maximum occupancy is 2
persons.
 If work site practice requires that any person who occupies an
elevated platform must wear a safety harness and lanyard, only 1
person should connect to a given anchorage point. Anchorage
points are present at each end of the anchorage weldment (see
arrows in FIG. 6). NO person should occupy the platform during load
transport. Maximum occupancy is 2 persons.
 Only use the platform on smooth, level, finished surfaces capable of
supporting the combined weight of the person(s) occupying the
platform and all equipment and/or material present on the platform,
the platform itself, the lift truck and operator.
 Avoid sudden stops or quick turns while transporting the platform.
 DO NOT drive the fork truck while the platform is occupied. If it
is necessary to reposition the fork truck or to relocate the platform,
fully lower the forks, require all persons to disconnect safety lanyards
and dismount the platform.
 Set the parking brake before lifting the platform.
FIG. 6: Anchorage
Points (arrows)
Anchorage
weldment
 Before transporting the platform, secure it to the (fork truck) mast.
Inspect the platform for signs of damage, and verify that the ramp
closure mechanism functions properly as shown in FIG. 7.
FIG. 7: Ramp Closure Mechanism
Closure plate
Closure
chain
Load equipment onto the platform:
1. Pull upwards on the free end of the closure chain (see Fig. 7 above) pull the chain through the opening in the closure
plate;
2. Lower the ramp;
3. Center the load/equipment on the platform;
4. Secure the load to the platform with tie-down straps or equivalent means. Attach the ends of the straps to the tie-
down D-rings (see FIG. 5 on p. 6). Make sure that the load is immobilized and secured to the platform.
5. Raise the ramp and secure it with the closure chain. Lift the platform only as high as necessary to avoid contact with
obstacles present along the path of travel. Transport the load to the desired location.
6. Adjust the elevation of the platform so that it rests on the surface that will receive the load/equipment (the bed of a
truck, for example). Make sure that the platform is level; adjust the tilt of the mast if necessary to level the platform.
Lower the ramp and release the tie-down straps. Transfer the equipment/load to the truck or other surface.
7. Raise the ramp and secure it with the closure chain; then return the platform to its storage location.
p. 7 of 8
Copyright 2010 Vestil Manufacturing Corp.