Vestil HDC-450 - Manual

1
VESTIL MANUFACTURING CORPORATION
2999 North Wayne St. • Angola, IN 46703
Phone (260) 665-7586 • Fax (260) 665-1339
E-mail: [email protected] • www.vestil.com
WARNINGS & SAFETY INSTRUCTIONS
Read owner's manual completely before operating unit!
* Remove drum & disconnect power before working on unit.
* Do not stand below any part of a raised drum stacker or
drum when unit is running.
* Stand clear of drum while operating the hand crank or
chain crank.
* Use only maintenance parts supplied or approved by the
manufacturer.
* Do not change pressure relief valve setting.
* Never operate stacker/rotator unless you are watching it.
* Never exceed maximum capacity of 800 pounds for FULL
drum: or 500 pounds for HALF-FULL drum.
* Load drum at the center of the cradle.
* Consult factory for uneven loading.
* Do not continue to pump on the foot pump pedal if the
cradle is not raising.
* Do not use brake fluids or jack oils. Use AW-32 hydraulic
oil or equivalent.
* Consult factory if adding or performing any modifications
to the original equipment.
* Make sure all operator safety labels are in place (p.14).
RECEIVING INSTRUCTIONS
Every unit is thoroughly tested and inspected prior
to shipment. However, it is possible that the unit may incur
damage during transit. If you see damage when unloading
make a note of it on the SHIPPER RECEIVER.
Remove all packing and strapping material, inspect
for damage. IF DAMAGE IS EVIDENT, FILE A CLAIM
WITH THE CARRIER IMMEDIATELY! Also, check the unit
size, type of power unit, etc., to ensure the unit is correct for
the intended application.
HYDRAULIC DRUM STACKER
MODEL HDC-450-60 / 72 / 84 / 96
OWNER'S
MANUAL
Revised 0708
A company dedicated to solving ergonomic
and material handling problems since 1953.
HYDRAULIC DRUM STACKER
HDC-450 SERIES
Foot Pump Troubleshooting Guide ............. 7
Hydraulic Drum Stacker/Boom
Exploded Parts Drawing ............................. 8
Parts List ..................................................... 9
Cradle Assembly
Exploded Parts Drawing ........................... 10
Parts List ................................................... 11
Warning Label Identifications .................... 12
Limited Warranty ....................................... 12
Contents
Warnings and Safety Instructions ....................... 1
Receiving Instructions ........................................ 1
Loading Instructions ........................................... 2
Operating Instructions ........................................ 2
Rack Specifications ............................................ 3
Periodic Maintenance Instructions ..................... 4
Operation............................................................ 5
Hydraulic Schematic .......................................... 6
Air Bleed Procedure ........................................... 6