Vestil LO-DC-MR User Manual

Owner's manual

Advertising
background image

1

VESTIL MANUFACTURING CORPORATION

2999 North Wayne St., Angola, IN 46703

Phone (260) 665-7586 · Fax (260) 665-1339

E-mail: [email protected] · www.vestil.com

SAFETY PRECAUTIONS

Read owner's manual completely before operating unit!
• Never exceed the maximum capacity of 1,000 pounds.
• Never load more than one drum at a time.
• Never load the unit unless you are watching it.
• Stand clear of drum while loading and unloading.
• Drum must be pushed all the way to the back of the

craddle before moving.

• Use caution in moving a loaded unit; avoid obstructions

and floor defects.

• Wear steel-toe shooes when operating.

RECEIVING INSTRUCTIONS

Every unit is thoroughly tested and inspected prior

to shipment. However, it is possible that the unit may incur
damage during transit. If damage is noticed when unloading,
make a note of it on the BILL OF LADING. Remove all
packing and strapping material, then inspect the unit again
for damage. IF DAMAGE IS EVIDENT, FILE A CLAIM WITH
THE CARRIER IMMEDIATELY!

WARRANTY

This product is warranted for 90 DAYS from date of

purchase to be free of manufacturing defects in material and
workmanship.

This warranty does not cover normal wear of parts

or damage resulting from any of the following: negligent use
or misuse of the product, use or application contrary to
installation instructions, or disassembly, repair or alteration
by any person prior to authorization from a factory
representative.

LO-PROFILE DRUM CADDIES
MODELS LO-DC-MR-A, LO-DC-PU-A & LO-DC-CI-A
MODELS LO-DC-MR, LO-DC-PU, LO-DC-CI & LO-DC-PH

OWNER'S
MANUAL

Revised 0507

16-126-104

A company dedicated to solving ergonomic and material
handling problems since 1955.

LO-PROFILE DRUM CADDIES

MODELS LO-DC-MR-A, LO-DC-PU-A

& LO-DC-CI-A

Ergonomic Solutions

ASSEMBLY INSTRUCTIONS

1)

Attach casters using hardware included.

2)

Bolt wheel assembly to cradle using hardware included.

3)

Slide Handle into Wheel Assembly

(Please refer to the next page for the assembly drawing)

OPERATION

1)

Align unit in front of drum, remove handle, grip drum with
handle.

2)

Tip drum up while guiding the cradle under the drum.

3)

Reattach handle and transport drum to desired location.

Contents
Safety Precautions ........................................ 1
Receiving Instructions ................................... 1
Warranty ........................................................ 1

Assembly Instructions .................................... 1
Operation ....................................................... 1
Parts List & Drawing ................................2 & 3

Advertising