Vestil LM-Boom - Manual (Page 22)

LM-series fork-mountable booms 01/11 rev. 11/14/2013
Page 22 of 28
Copyright 2013 Vestil Manufacturing Corp.
Operation Instructions:
Review “Safety Guidelines” on p. 2-3 before using the boom.
1. Insert fork truck tines into the fork pockets and drive as far forward as possible; then lower the forks completely.
The drawings below demonstrate this step:
2. Securely connect the boom to the carriage of the fork truck with the safety chain.
Wrap the safety chain (or strap) around the fork carriage so that it cannot slide free of the carriage; then fasten
the hook to the chain/strap. There should be no slack in the chain/strap. The only purpose of the safety chain is to
prevent the boom from sliding off of the forks—it is NOT intended or designed to bear the full load rating.
3. [Telescoping models only] Adjust the boom length:
a. Loosen the X-handle locking bolt (“locking bolt”), by turning it counterclockwise.
b. Grasp the adjustment handle at the end of the boom and pull the boom to the desired length.
c. Tighten the locking bolt by turning it clockwise. Turn the locking bolt until it cannot be tightened more.
Fig. 6: Step 1 - Securely connect boom to fork truck
Fork
truck
Fork
truck
Outer edges
of fork pockets
Fully lower the forks
to rest against the
bottoms of the fork
pockets
Fig. 7: Step 3 - Manually adjust degree of boom extension
Boom extension
adjustment handle
Turn X-handle locking bolt
counterclockwise to loosen
Turn X-handle locking
bolt clockwise to tighten
Fork carriage
Safety chain/strap
wrapped around fork
carriage & snap hook
fastened to cold shut
Snap hook Cold shut
Boom sleeve
Boom sleeve
Boom sleeve
Boom sleeve