VIAIR 87P - Manual (Page 3)

87P PORTABLE COMPRESSOR
FEATURES:
1. Built-In 120 PSI Pressure Gauge
2. LED Work Light/Power Indicator
3. Dual Battery Clamps with 20-amp Inline Fuse Holder
4. Deluxe Carry Bag with Bright Orange Lining for Enhanced Visibility
5. 3-Pc. Inflation Tips Kit
6. Piston Type Compressor
7. Oil-Less Design
8. Gearless Direct-Drive Motor
9. Permanently Lubricated Bearings
10. Compact Size for Easy Carrying and Storage
11. Solid Brass Twist-On Tire Chuck
12. Aluminum Alloy Cylinder
OPERATING INSTRUCTIONS:
IMPORTANT: Engine must be running while using this compressor.
Before attaching air compressor’s power cord to power source, check to make sure that the
ON/OFF switch of your compressor is in the OFF position. Attach the Positive battery clamp (Red)
to the Positive terminal of the battery and the Negative battery clamp (Black) to the Negative terminal
of the battery.
CAUTION: Your Portable Air Compressor is Moisture and Dust Resistant, but NOT WATER OR DUST
PROOF. Never place compressor in soft sand while running the compressor. Vibration from the
compressor will cause the compressor to settle into soft sand, resulting in compressor drawing in
foreign particles. Never expose compressor to water while running the compressor.
TIRE INFLATION:
1. Attach the end of the air hose to the tire valve stem.
2. Turn the compressor power switch to ON and begin to inflate tire.
3. When the pressure gauge indicates the desired pressure, switch the unit OFF and
remove the air hose from the tire valve stem.
CAUTION: To avoid over inflation, never exceed recommended pressure. Doing so may cause
articles to burst and can cause serious bodily injury. Always make sure the Portable Compressor’s
power cord is uncoiled and fully extended when using your air compressor to avoid overheating the
power cord.
FOR ALL OTHER INFLATABLE OBJECTS, INCLUDING
BICYCLE TIRES, TOYS, AND SPORTS BALLS:
IMPORTANT: Engine must be running while using this compressor.
1. A selection of inflation tips is provided to fit some inflatable objects.
Simply screw the appropriate nozzle into the tip of the air hose.
2. Attach the appropriate nozzle to article to be inflated and turn the power switch
to the ON position.
3. When article is inflated to desired firmness, turn the compressor off. Do not over inflate.
USER MANUAL