VIAIR High-Pressure (Universal) - Manual (Page 2)

IMPORTANT SAFETY INSTRUCTIONS
CAUTION - To reduce risk of electrical shock or electrocution:
- Do not disassemble. Do not attempt repairs or modifications. Refer to qualified service
agencies for all service and repairs.
- Do not use this product in or area where it can fall or be pulled into water or other liquids.
- Use this compressor with 12-volt DC systems only.
- Never leave product unattended during use.
WARNING - To prevent injury:
- Never allow children to operate this compressor. Close supervision is necessary when this
compressor is being used near children.
- This compressor will become very hot during and immediately after use. Do not touch any part of
this compressor with bare hands other than the ON/OFF switch during and immediately after use.
- Do not use this product near flames or explosive materials or where aerosol products are being used.
- Do not operate this product where oxygen is being administered.
- Do not pump anything other than atmospheric air.
- Never use this product while sleepy or drowsy.
- Do not use any tools or attachments without first determining maximum air pressure needed
for that tool or attachment.
- Never point any air nozzle or air sprayer toward another person or any part of the body.
- This air compressor is equipped with an Automatic Reset Thermal Protector, and can automatically
restart after the thermal protector resets. Always cut off power source when thermal
protector becomes activated.
- Wear safety glasses or goggles when operating this product.
- Use only in well ventilated areas.
INSTALLATION
Please read and follow the Installation Instruction carefully to avoid injury or damage to the
compressor or your vehicle. Before installation, plan your install and add fittings before the tank
is bolted down.
Guidelines for Selecting Mounting Location:
The selection of a proper mounting location for your 2on2 Platform will help ensure a long and
trouble free service life. Please pay close attention to the following guidelines:
FOR 2007-2011 JK APPLICATIONS - P/NS 30001 & 30005:
To simplify installation, it is recommended that the air box and intake tubing be removed
during installation.
1. Using the provided crossmember bracket, secure to the JK crossmember using the provided
U-bolts, washers and locking nuts. Set all brackets in place and only snug hardware initially.
2. After the final positioning is located, that allows proper clearance, torque locking nuts to
approximately 25-30 ft lbs torque each, (distributed evenly) to ensure solid mounting for
the 2on2 Platform.
3. The compressor is moisture & splash resistant, but NOT WATERPROOF. Do not mount 2on2
in locations where the unit is likely to become submerged in water.
INSTALL PROCESS:
1. Bracket
2. 2on2 Kit
3. Torque All Hardware
FOR UNIVERSAL APPLICATIONS - P/NS 30016 & 30018:
1. Select a FLAT, UPRIGHT AND SECURE location where the 2on2 can be mounted.
2. To maximize air compressor performance, locate compressor as CLOSE TO THE BATTERY
as possible so that length of positive lead wire required is at a minimum.
3. The compressor is moisture & splash resistant, but NOT WATERPROOF. Do not mount 2on2
in locations where the unit is likely to become submerged in water.
USER MANUAL
2on2 Bolt-On Platform