VIAIR Constant Duty (Base Model Kit) - Manual (Page 3)

MOUNTING AND WIRING
1. Disconnect ground cable from vehicle’s battery.
2. Position the air compressor in the location where it will be mounted.
3. NOTE: For remote inlet air filter installation, refer to instructions included in the
Remote Inlet Air Filter Pack.
4. Make sure that your compressor setup is properly fused.
5. Before connecting to power source, re-check your system to make sure that all electrical
connections are made properly.
6. Connect power lead to the battery. It is recommended to provide switched power for the system,
that is only turned on when the ignition of the vehicle is also energized in case of any air leaks
that may allow the system to turn on and drain your battery during periods when the vehicle
might remain parked. This is especially important when using a small reservoir, as is supplied
with all ADA Base Model Kits.
7. Ensure that the drain valve located on the underside of the ADA Base Model reservoir is closed.
8. When power is made available to the ADA Base Model, the system will automatically turn on
and fill the ADA reservoir.
9. When the cutoff pressure of the ADA Base Model has been reached, the system will
shut off automatically.
10. Inspect all air line connections for leaks with soap and water solution. If a leak is detected, the
connection may not be made properly. Re-do any connections that are leaking. The use of
thread locker is recommended for all fittings. (Avoid the use of Teflon tape).
ADA BASE MODEL KIT COMPONENTS LIST:
Qty. 1: 400C or 450C Compressor
Qty. 1: Extruded Aluminum Air Tank (12-port)
Qty. 1: Pre-installed Safety Valve
Qty. 1: Pre-installed 1/8” NPT Drain Cock
Qty. 1: Pre-installed 85/105 PSI Pressure Switch (P/N 42045 & P/N 45052)
or
Qty. 1: Pre-installed 110/145 PSI Pressure Switch (P/N 42047 & P/N 45054)
Qty. 8: Pre-installed 1/4” NPT Recessed Port Plugs
Qty. 1: Pre-installed Quick Connect Coupler
Qty. 1: 40-amp Relay
Qty. 2: 1/4” NPT to 1/8” BSP Adapters
Qty. 1: 1” NPT M Barbed Fitting for 1/4” Air Line (For Remote Mount Air Filter Installation)
Qty. 1: 1” NPT F Barbed Fitting for 1/4” Air Line (For Remote Mount Air Filter Installation)
Qty. 1: Coiled Air Line (For Remote Mount Air Filter Installation)
Qty. 1: Air Filter Housing
Qty. 2: Replacement Air Filter Elements
Qty. 1: Mounting Hardware
AUTOMATIC DEPLOYMENT AIR BASE MODEL KIT