AMX NXD-CV7 - Manual (Page 35)

CV7 Touch Panel Accessories
27 7" Modero Widescreen Touch Panels
There is one LED indicator on the front of each battery slot that indicates the status of that slot. The
blink patterns for these LEDs are described in the following table:
Charging the NXT-BP batteries using the NXT-CHG
1. Review the Checking the NXT-BP charge section on page 23 to confirm the percentage of
charge remaining on the batteries.
2. Provide power to the charger (as outlined in the Powering the NXT-CHG section on page 26).
3. Align the battery connector with the corresponding charge slot.
4. Firmly insert the battery into the desired slot until the battery is both securely located within
the slot and there is activity from the corresponding Slot LED. Refer to the Reading the NXT-
CHG LED Indicator section on page 26 section for LED information.
Recalibrating the batteries
The recalibration process increases the accuracy of the battery charge level. Recalibration of the
batteries is only done upon a user request from the Modero on-screen Battery Base page.
1. Place the selected battery securely into Slot 1 (left slot) until there is activity on the
Slot 1 LED.
2. Push the Recalibration pushbutton (located between the two slots) to initiate recalibration in
the left bay only.
• Off: No battery detected.
• Green Flashing: Fast charging.
• Green Solid: Fully charged.
• Yellow Flashing: Recalibration in process.
• Yellow/Green: Recalibration complete.
• Yellow Solid: Standby (waiting for other battery to charge).
• Red Flash: Error (problem with either the battery connection to the internal slot, or with
the battery itself).
Recalibration can only be done within Slot 1 on the NXT-CHG.