AMX NXD-CV7 - Manual (Page 39)

Installation
31 7" Modero Widescreen Touch Panels
Installing the Button Trim Ring
The outer No-Button Trim Ring is secured to the Faceplate with plastic latches. In order to
re-install the Button Trim Ring back onto an NXD panel which has had the default Button Trim
Ring features removed; you must first remove the No-Button Trim Ring:
1. To remove the Faceplate, simply pull it away from the panel by gently tugging it outwards until
the entire Faceplate comes away from the panel.
2. Turn the Faceplate over to expose the inside surface and view the Trim Ring latches.
3. In a single motion, press down and then outwards on the three Trim Ring latches located along
the top of the internal surface of the Faceplate to begin removing the Trim Ring. Removing the
Internal Faceplate from the panel exposes the pushbuttons openings left from an earlier
removal of the pushbuttons and LEDs.
4. Gently tug along the edges of the No-Button Trim Ring and work your way around the edges
to remove it from the Faceplate (FIG. 32).
5. From along the internal surface of the Faceplate, install the six buttons by firmly inserting them
into the button openings until the Button latch secures the button in place (FIG. 32).
6. Install the pair of clear light pipe strips by pushing light pipes over the two black light pipe
latches.
7. Grasp the Button Trim Ring on both sides and fit it into the groove along the outside surface of
the Faceplate (made available by the removal of the previous Trim Ring).
FIG. 31 Inserting the No-Button Trim Ring
No-Button Trim Ring
Faceplate (outer surface shown)
Hollow button openings