AMX NXD-CV7 - Manual (Page 43)

Installation
35 7" Modero Widescreen Touch Panels
2. Verify the incoming power, RJ-45 audio/video, Ethernet, and USB cables have been properly
threaded through the wiring knockouts on the left of the conduit box. Leave enough slack in the
wiring to accommodate any re-positioning of the panel.
3. Connect all data and power wiring connectors to their corresponding locations along the side
of the (un-powered) NXD touch panel.
Verify that the terminal end of the power cable is not connected to a power source before
plugging in the 2-pin power connector.
The USB connectors can be from either a USB extension cable, or a wireless USB RF
transmitter.
4. Test the incoming wiring by connecting the panel connections to their terminal locations and
applying power. Verify that the panel is receiving power and functioning properly to prevent
repetition of the installation.
5. Disconnect the terminal end of the power cable from the connected PSN power supply.
6. Carefully slide the main NXD-CV7 unit (B in FIG. 35) into the conduit box, so that all
Mounting Tab lie flush against the conduit box (C in FIG. 35).
7. Insert and secure four #4-40 Mounting Screws (included) into their corresponding holes
located along the sides of the NXD.
8. Replace the Faceplate/Trim Ring (A in FIG. 35) back onto the main NXD unit
(B in FIG. 35). Make sure to align the Microphone, Light, and PIR Motion sensor locations to
their respective openings on the front faceplate/bezel.
9. Reconnect the terminal RJ-45, Ethernet, USB, and any optional audio/video wiring to their
respective locations (outside the conduit box) on either the NXA-AVB/ETHERNET Breakout
Box, Ethernet port, or NetLinx Master.
10. Reconnect the terminal power connector on the PSN and apply power.
Installing the NXD into drywall using Expansion Clips
Expansion clips are mounted through the three oval holes located along the rim of the NXD-CV7.
As the screw is tightened, the clip bends toward the insertion hole and into the wall. This bending
creates a "grip" on the wall by either pressing onto the wall or by securing the drywall between the
housing and the drywall clip.
The most important thing to remember when mounting the NXD is that the outer frame
(Mounting Tabs) must be installed flush against the mounting surface.
Refer to SP-2258-01 for detailed installation dimensions (reproduced in FIG. 36).
It is recommended that you cutout the surface slightly smaller than what is outlined in the
installation drawings so that you can make any necessary cutout adjustments.
Don’t disconnect the connectors from the touch panel. The unit must be installed with
the attached connectors before being inserted into the conduit box.