AMX NXD-CV7 - Manual (Page 46)

Installation
38 7" Modero Widescreen Touch Panels
12. Reconnect the terminal RJ-45, Ethernet, USB, and any optional audio/video wiring to their
respective locations on either the NXA-AVB/ETHERNET Breakout Box, Ethernet port, or
NetLinx Master.
13. Reconnect the terminal power connector on the PSN and apply power to the panel.
Installing the NXD into a Flat Surface using #4 screws
Mounting screws (#4-40, included) are secured through two sets of circular holes located at the left
and right sides of the NXD-CV7. The most important thing to remember when mounting the NXD
Wall Mount is that the outer frame (Mounting Tabs) must be installed flush against the mounting
surface.
Refer to SP-2258-01 for detailed installation dimensions (reproduced in FIG. 38).
It is recommended that you cutout the surface slightly smaller than what is outlined in the
installation drawings so that you can make any necessary cutout adjustments.
1. Remove any screws or nails from the surface before beginning the cutout process.
2. Cut out the surface for the NXD Wall Mount unit using the dimensions shown in FIG. 38.
3. Remove the Faceplate/bezel (A in FIG. 39) from the main NXD unit (B in FIG. 39) by
gripping the faceplate and pulling with gentle outward force.
FIG. 38 NXD-CV7 Wall Mount panel dimensions using #4-40 mounting screws