AMX NXD-CV7 - Manual (Page 48)

Installation
40 7" Modero Widescreen Touch Panels
9. Insert and secure four #4-40 Mounting Screws (included) into their corresponding holes
located along the sides of the NXD-CV7 (using a grounded Phillips-head screwdriver) until the
unit is secure and flush against the wall (FIG. 39).
10. Replace the Faceplate/Trim Ring on the main unit. Make sure to align the Microphone, Light,
and PIR Motion sensor locations to their respective openings on the front bezel/faceplate.
11. Reconnect the terminal RJ-45, Ethernet, USB, and any optional audio/video wiring to their
respective locations on either the NXA-AVB/ETHERNET Breakout Box, Ethernet port, or
NetLinx Master.
12. Reconnect the terminal power connector on the PSN and apply power.
Installing an NXD-CV7 into an (optional) Rack Mount Kit (NXA-RK7)
The NXA-RK7 is a 19" (48.3 cm) metal rack-mount (with black matte finish) measuring 4 rack
units high.
1. Remove the Faceplate/Trim Ring assembly from the main CV7 unit.
2. Thread the incoming power, RJ-45 audio/video, Ethernet, and USB wiring (from their terminal
sources) through the surface opening, leaving enough slack in the wiring to accommodate any
re-positioning of the panel.
3. Connect all data and power wiring connectors to their corresponding locations along the left
side of the (un-powered) NXD touch panel.
Verify that the terminal end of the power cable is not connected to the a power supply
before plugging in the 2-pin power connector.
The USB connectors can be from a either a USB extension cable, or a wireless USB RF
transmitter.
4. Test the incoming wiring by connecting the panel connections to their terminal locations and
applying power. Verify that the panel is receiving power and functioning properly to prevent
repetition of the installation.
5. Disconnect the terminal end of the power cable from the connected power supply.
6. Carefully insert the CV7 panel into the NXA-RK7.
7. Secure the panel to the NXA-RK7 mount by first inserting and then tightening the four #4-40
screws.
8. Insert the NXA-RK7 (with connected NXD unit) into the equipment rack, making sure to align
the screw holes along the sides on the NXA-RK7 with the holes in the equipment rack.
9. Use a grounded Phillips-head screwdriver to secure the NXA-RK7 to the equipment rack using
#10-32 screws (included).
10. Replace the Faceplate/Trim Ring assembly back onto the main CV7 unit, making sure to align
the Microphone, Light, and PIR Motion sensor locations to their respective openings on the
Faceplate/Trim Ring assembly.
Don’t disconnect the connectors from the touch panel. The unit must be installed with
the necessary connectors before being inserted into the equipment rack.