AMX NXD-CV7 - Manual (Page 78)

Configuring Communication
70 7" Modero Widescreen Touch Panels
Master Connection section - NetLinx Master Ethernet IP Address - Listen Mode
In this mode, you must add the Modero panel IP Address into the URL List of the Master (using
NetLinx Studio). This mode sets the Modero panel to "listen" for broadcasts from the Master (using
the panel IP from its URL list).
1. Obtain either a Static IP for the Modero panel (from your System Administrator) or a DHCP
Address from the IP Settings of the System Connection page.
The DHCP/Static field (in the IP Settings section of the System Connection page) must
be set to DHCP to get Dynamic IP information for the panel.
Press the on-screen Reboot (from the Protected Setup page) to both save any changes and
restart the panel.
After power-up, press the grey Front Setup Access button for 3 seconds to access the
Setup page.
Navigate to the Setup > Protected Setup > System Connection page and note the newly
obtained Dynamic IP Address information from the IP Settings section. This information
is then entered into the URL List for the connected NetLinx Master.
2. Toggle the Type field until Ethernet is selected (from the Master Connection section of the
System Connection page).
3. Press the Mode field (to set the connection Mode) until the choice cycles to the word Listen.
The System Number and Master IP/URL fields are then greyed-out.
4. Enter a username and password (into their respective fields) if the target Master has been
previously secured.
5. Select the OnLine Tree tab from the Workspace window.
6. Select Diagnostics > URL Listing from the Main menu (FIG. 64).
7. Enter the System and Device number for the specific Master associated with your panel (as
seen in the OnLine Tree tab).
8. Click Add and enter the IP Address of the Modero touch panel into the Add URL dialog.
9. Click OK to enter your IP Address and add it to the list.
10. Click Done once you are finished adding your panel information to the list.
FIG. 64 URL List dialog
System Address
reflects the value
set in the Device
Addressing tab
Used to obtain an
existing URL
Used to set the
URL List
List from Master
on Master