Wade Antenna LT Series - Manual

LT SERIES
Model
LT
LT
LT
LT
Series No.
1
2
3
4
Max. Height
64'
56'
48'
40'
Max. Load
3 sq. ft. projected area - 60 lbs of weight
6 sq. ft. projected area - 120 lbs of weight
9 sq. ft. projected area - 180 lbs of weight
12 sq. ft. projected area - 240 lbs of weight
Mast
Clamp
Plates
8 foot
sections
Climb
Shield
Compact Tower
Package
Unique
beaded
channel
leg resists
bending
Hinge-up Base
A
B
Top of tower with mast
clamp plate installed
DELHI LIGHTING TOWER PRODUCTS
Width = 1.67 m
BASE STUBS
IN CONCRETE
76mm
CLEARANCE
152 x 152mm
WIRE MESH
NTS
DEPTH =
1.2 m
CONCRETE REQUIRED = 3.34 cu.m.
Each tower is shipped with 3
concrete-base stubs. It is recommended
that a square hole be dug 4 feet deep
and 16" wider than the base section of
the tower. Hinge-up base stubs are also
available for use in concrete. These are
recommended where facilities are
available for raising or lowering complete
tower. On parking lot installations, all
concrete bases should extend past
bumper height.
BASES - CONCRETE
Towers are manufactured in 8 ft.
sections, which nest compactly for
shipping and ease of handling and
storage. Rivets are stainless steel and
all bolts, nuts and lockwashers are
heat treated and zinc plated.
CONSTRUCTION
The top section of each tower comes
complete with 2 heavy gauge
galvanized mast clamp plates. Each
plate has a heavy duty cast aluminum
mast clamp that will accept masts up
to 2 ½" O.D. (see figure below)
TOP SECTIONS
(Also used to enclose ballasts)
Shields are manufactured from
galvanized sheet and are fastened to
the braces with sheet metal screw.
Shields are 8 feet high.
CLIMB SHIELDS
For Parks and Recreational Areas, Farms, Industry, Parking Lots, and many other applications.
Lighting towers are available in the following four series. Load figures given are for lights mounted
at the top of the tower, and include the weight of mast and fittings. Each series designates the
load carrying capabilities and maximum height. Our new Towers have been enhanced in both leg
profile and taper facilitating an easier installation and improved tower structure.
NOTE: All ballasts should be mounted at base of tower.
A
B
26" Sections 01T, 02T
41" Sections 03T, 04T