WARN ProVantage 2500-s - Manual (Page 3)

WARN INDUSTRIES
5 89294A0
GENERAL SAFETY PRECAUTIONS
AVOID WINCH AND EQUIPMENT
DAMAGE
• Always avoid side pulls which can pile up winch
rope at one end of the drum. This can damage
winch rope or winch.
• Always ensure the clutch is fully engaged or
disengaged.
• Always use care to not damage the vehicle frame
when anchoring to a vehicle during a winching
operation.
• Never submerge winch in water.
• Always store the remote control in a protected,
clean, dry area.
N O T I C E
MOVING PARTS ENTANGLEMENT
HAZARD
Failure to observe these instructions could
lead to minor or moderate injury.
To avoid injury to hands or fi ngers:
• Never leave remote control where it can be
activated during free spooling, rigging, or when the
winch is not being used.
• Never leave the winch remote control plugged in
when installing, freespooling, rigging, servicing or
when the winch is not being used.
CHEMICAL AND FIRE HAZARD
Failure to observe these instructions could
lead to serious injury or death.
• Always remove jewelry and wear eye protection.
• Never route electrical cables across sharp edges.
• Never route electrical cables near parts that get
hot.
• Never route electrical cables through or near
moving parts.
• Always place the supplied terminal boots on
wires and terminals as directed by the installation
instructions.
• Never lean over battery while making
connections.
• Never route electrical cables over battery
terminals.
• Never short battery terminals with metal objects.
• Always verify area is clear of fuel lines, fuel tank,
brake lines, electrical wires, etc., when drilling.
• Always consult operator’s manual for proper
wiring details.
• Always insulate and protect all exposed wiring
and electrical terminals.
CUT AND BURN HAZARD
Failure to observe these instructions could
lead to minor or moderate injury.
• Never let winch rope slip through your hands.
CAUTION
WARNING CAUTION
WARN INDUSTRIES
89294A0 6
SAFE WORKING CONDITIONS
Safety
When installing your ATV/UTV winch
system, read and follow all mounting and
safety instructions.
Always use caution when working with
electricity and remember to verify that no
exposed electrical connections exist before
energizing your winch circuit.
For specifications and performance data,
refer to the specification sheet supplied with
your winch.
Figure 1: To install the complete kit, you will need to mount the winch, contactor
handlebar mounted Mini-rocker switch and remote socket (optional on some models). Mounting locations may vary depending
on make and model of the ATV/UTV. Read and understand the following instructions to choose the appropriate mounting
locations.