Magnetic clutch rebuild procedure – Warner Electric Dairy Capping Headsets User Manual
Page 2
Advertising
2 Warner Electric • 800-825-9050
P-2096-WE
Figure 4
Remove two set screws using a 3mm (YTL1-
0015) or 1/8” (YTL1-0009) hex wrench.
Remove the third set screw in the slot on the
backside of the housing using a 2.5mm (YTL1-
0014) or 3/32” (YTL1-0007) hex wrench.
Remove three button head Torx screws using
3mm (T-15) Torx security bit (YTL1-0002).
Place clutch shaft hex into vice. Remove the top
nut using a FIX-0004.
Figure 1
Figure 2
Figure 3
Magnetic Clutch Rebuild Procedure
Advertising