Warner Electric CBC-160-MV - Manual (Page 2)

Specifications
Input 208-575VAC, 50/60 Hz.
Output Range 30-100 VDC (adjustable). 0.5
amps
Fusing
(Optional)
1 amp, 250 V fast-blow
Ambient
Temperature 0 to 122 F, (-18 to 50)C
Switching Supplied by Customer
Cycle Rate Consult Warner Electric’s Master
Catalog, form no. P-1000, for energy
dissipation of your application.
Set-Up The recommended settings for
Electro module Fail Safe Motor
Brakes are as follows.
To insure optimum release, it is factory set to
90VDC. Adjust the potentiometer on the control to
the required brake coil voltage as measured with a
voltmeter. The recommended voltage listed below
is based on nominal line voltage.
Model Voltage
UM - 50 70-100 volts DC
UM - 100 70-100 volts DC
UM - 180 90 volts DC
UM - 210 70-100 volts DC
UM - 215 70-100 volts DC
Reorder Information
2 Warner Electric • 800-825-9050 819-0501
Failure to follow these
instructions may result in product damage,
equipment damage, and serious or fatal injury
to personnel.
Introduction
The Warner Electric CBC-160MV is a family of
clutch/brake controls conveniently built into the
conduit box cover of the Elecctro Module line of
electromagnetic clutches and brakes. The CBC-
160MV control is a single channel device, that is
adjustable for precise operation of the brake, with
flexible adjustable for precise operation of the
brake, with flexible voltage input from 208 to 575
VAC. This control is designed for operation with
Warner Electric’s permanent Magnet 90VDC Fail
Safe Motor Brakes. It may also be used with any
Warner Electric 90VDC clutch/brake.
Model Part Number
CBC-160-MV 6013-448-004
Contents
Indtroduction . . . . . . . . . . . . . . . . . . . . . . . . . . . . 2
Specifications. . . . . . . . . . . . . . . . . . . . . . . . . . . . 3
Warranty . . . . . . . . . . . . . . . . . . . . . . . . Back Page