Warner Electric Autogap 500 - Manual (Page 2)

Step 4
Repeat Step 3 above for the remaining (3) drive pins
inserting them from opposite side of armature hub
through remaining (3) holes.
Step 5
Holding the pins in position. Place the armature hub
over one armature. Note: Make sure that the straight
springs on the armature bosses fit into the grooves in
the armature hub. Drive pins require application of
Grade "AA" Loctite Sealant on threads.
Step 6
Draw these (3) drive pins up tightly until shoulder of pin
is against face of armature boss (since threads are
class No. 3 fit, pins may seem to bind.)
Step 7
Place the armature hub and armature assembled in
steps 5 & 6 over the remaining armature.
Note: Make sure that the three remaining straight
springs on the armature bosses fit into the grooves in
the armature hub. Drive pins require application of
Grade "AA" Loctite Sealant on threads.
2 Warner Electric • 800-825-9050 P-1381 • 819-0112
Armature
Straight Spring
Detent
Spring
Retainer
Conical
Spring
Drive Pin
Armature Hub Armature Boss
Autogap Installation for Clutch/Brake
Combination
Step 1
Place straight springs over armature bosses on back
side of both armatures.
Step 2
Compress conical spring against retainer ring by sliding
detent spring towards head of all 6 pins.
Step 3
Insert (3) of the compressed drive pins through the
armature hub so that the threaded end of the pins
comes through on the side of the armature hub with
the groove around the hole.
Compressed