Warner Electric Autogap 825-1525 Special Heavy Duty User Manual
Installation instructions
Warner Electric
800-825-9050
Special Heavy Duty Autogap Installation for
Sizes 825-1525 Basic Brakes & Clutches
Installation Instructions
P-1399
819-0312
Step 2. Compress
heavy spring (yellow)
against retainer ring
by sliding detent spring
towards head of pin.
(See Figure 2)
Assembly Instructions
Step 1. Place straight springs (red) over arma-
ture boss on back side of armature.
(See Figure 1)
Figure 1
Step 3. Insert assembled drive pins through
segmented side of armature, through straight
(red) springs and into threaded holes in
armature hub. (See Figure 3)
Figure 3
Be sure that straight red springs
do not get caught under shoulder of drive
pins.
Compressed
Failure to follow these
instructions may result in product damage,
equipment damage, and serious or fatal
injury to personnel.
Figure 2
Armature Boss
Straight Spring
(Red)
Detent Spring
Retainer
Retainer
Ring
Detent
Spring
Drive Pin
Heavy
Spring
(Yellow)
Armature