Warner Electric Electro-Packs EP-250-W, EP-400-W - Manual (Page 2)

2 Warner Electric • 800-825-9050 P-1510 • 819-0475
Contents
Product Description . . . . . . . . . . . . . . . . . . . . . 2
Installation Instructions . . . . . . . . . . . . . . . . . . . 3
Electrical Connections. . . . . . . . . . . . . . . . . . . . 3
Burnishing . . . . . . . . . . . . . . . . . . . . . . . . . . . . 3
Maintenance . . . . . . . . . . . . . . . . . . . . . . . . . . . 3
Servicing Worn Components . . . . . . . . . . . . . . 3
Troubleshooting . . . . . . . . . . . . . . . . . . . . . . . . 4
Clutch/Brake Selection Information
Horsepower vs. Shaft Speed . . . . . . . . . . . . 5
Part Numbers . . . . . . . . . . . . . . . . . . . . . . . 5
Mechanical Specifications . . . . . . . . . . . . . . 5
Electrical Coil Data. . . . . . . . . . . . . . . . . . . . 5
Dimensions . . . . . . . . . . . . . . . . . . . . . . . . . 5
Warranty . . . . . . . . . . . . . . . . . . . . . . Back Page
Failure to follow these
instructions may result in product damage,
equipment damage, and serious or fatal
injury to personnel.
Base Mounted Clutch/Brake Combinations
in a Rugged Washdown Housing
Meets electrical codes
UL Listed or CSA Certified.
Pre-packaged
Over 20 major
components
have been pre-engi-
neered and pre-
assembled in a typical
Electro Pack. Ready-
to-go, straight from
the box.
Foot mounted
Bolt-it-down and wire-it-up. Allows for
quick replacement/reduced downtime.
Maintenance free
Never needs lubrication.
Self-adjusting for wear of
clutch-brake friction faces.
Consistent performance.
Heavy duty bearings
Sealed and shielded to
resist contamination.
Properly aligned for
maximum performance.
Product Description
The Washdown Electro-Pack (EP-W) is a
pre-assembled foot mounted clutch/brake
package complete with input and output shafts.
EP-Ws are specifically designed for applications
that require washing with high-pressure spray
systems. Their smooth exterior reduces the
accumulation of food particles or other
contaminants, which can cause bacteria growth.
They are coated with a USDA approved nontoxic
white paint that is extremely resistant to chipping
and corrosion. All fasteners, shafts, and keys are
made from stainless steel to prevent corrosion,
and the bearings are sealed and shielded to
prevent contamination during washdown.
EP-Ws are ready to be installed in all standard
power transmission systems using V-belts and
pulleys, chains and sprockets, in-line couplings,
timing belt drives, or gear trains.
Corrosion Resistant
Stainless steel shafts,
keys and fasteners.
BISSC Certified
Smooth exterior with USDA
approved white coating.