Warner Electric 1300-77 12 Volt Utility Controller for 4, 6 or 8 - Manual (Page 2)

2 Warner Electric • 800-825-9050 P-1379 • 819-0094
Mounting Under Instrument Panel
1. Position the controller under the instrument
panel to the left or right of the steering
column, based on available space and driver
preference.
2. While sitting in a normal driving position,
place the controller so its handle is within
easy reach.
3. Remove the controller cover and, while
holding the controller in place, select at least
two holes through the case which best mount
the controller. Mark the underside of the
instrument panel through these holes.
4. Drill 3/16" diameter holes where marked,
being careful not to damage anything under
the instrument panel.
5. Attach the controller with 3/16" bolts, nuts
and lockwashers, and tighten securely. Bolt
heads are to be inside the controller.
MOUNT ON EITHER SIDE
Introduction
The Warner Electric manually operated Utility
Controller operates 4, 6, or 8 twelve-volt electric
wheel brakes. Some of the features of this
control are:
• Highly sensitive for accurate brake control
• Rated at 30 amperes
• Manually operated
Installation Instructions
These instructions provide for ease of
installation. Please follow them carefully. The
basic installation steps are:
1. Mount the controller inside the towing
vehicle.
2. Connect the controller electrically.
MOUNTING HOLES
Figure 1 Figure 2
Failure to follow these
instructions may result in product
damage, equipment damage, and serious
or fatal injury to personnel.