Warner Electric Gen 2 Ceramic Faced Clutch_Brake UniModule UM-50C, UM-180C - Manual (Page 4)

Figure 2b
Mounting to a Reducer
1. Warner Electric UniModules are furnished
with a hardened key pre-mounted on the
output shaft.
2. Align the output shaft and key of the
module with the corresponding bore and
keyway of the reducer. Slide the assembly
together as shown in Figure 3.
Figure 3
3. Bolt the module to the reducer flange.
The four (4) bolts that are required
(3/8-16UNC2A) are typically provided with
the reducer. Tighten to 18-22 foot pounds
of torque.
Installing the Base Mount
Model 2030-C UniModules are designed to be
base mounted as shown in Figure 4.
Optional Base Mount Kit,
Warner Electric part numbers:
UM-50..................................5370-101-004
UM-180................................5370-101-002
Figure 4
1. The pilot diameters on each end of the
UniModule will mate with the pilot
diameters on the base.
2. Secure the base to the UniModule with the
four (4) bolts provided. Tighten to 18 to 22
foot pounds.
Warner Electric • 800-825-9050 P-273-10 • 819-0532 4