AMX 68 - Manual (Page 10)

Programming Alarm System Features
All programmable alarm features are accomplished by turning the ignition
key on (or starting the vehicle) and flicking the valet switch on and off a
preset number of times.
1. Remove the alarm from Valet Mode. Programming cannot be accessed
while the alarm is in Valet Mode, indicated by the LED on solid red.
2. Select the feature you wish to program from the "Programming Table for
Alarm Features." Note the number of chirps.
3. Turn the ignition key to the "ON" position.
4. Within 10 seconds, begin flicking the valet switch on and off. The siren
will chirp one time each time you flick the switch on, then off.
5. Continue flicking the switch on and off until you reach the number of
chirps associated with your chosen feature.
NOTE: Stop on the chirp.
6. After a 3 second pause, you will hear 1 or 2 chirps to confirm that you
have changed the setting of that feature.
7. Turn the ignition key off.
8. Repeat steps 1-7 for any other feature you wish to program.
Pro gram ming Ta ble for Alarm Fea tures
Fea ture
Fac tory
Set ting
# of
Chirps
Sec on dary Ac tion
Passive/Active
Arming
Passive 4
Wait 3 seconds, the siren chirps once for active or
twice for passive.
Passive Door
Locking
OFF 5
Wait 3 seconds, the siren chirps once for OFF or
twice for ON.
Remote Arming
Siren Chirps
ON 6
Wait 3 seconds, the siren chirps once for OFF or
twice for ON.
10
AMX 68 Owner's Manual 12/29/97