WEATHER GUARD 178-X-01 through 181-X-01 - Manual

DANGER
PARTS LIST
TOOLS REQUIRED
INSTALLATION TIME
PRODUCT REGISTRATION
WWW.WEATHERGUARD.COM
OPERATORS MANUAL
ALUMINUM LOW-PROFILE SIDE BOX
MODELS 178-X-01 through 181-X-01
-ATTENTION-
(2) Keys
(1) Installation Tool
Reduced 65% (not lines)
(2) Legs
(8) 5/16”-18 Blind Fastener
(8) 5/16” Lock Washers
(8) 5/16” Flat Washers (1) Retaining Washer
Note: The rubber mounting pad
comes as a single piece and
must be separated into two
pieces, one for each side of the truck.
(2) Rubber Mounting Pads
(1) Aluminum Low-Profile
Side Box
TRUCK AND VAN EQUIPMENT
Model #_____________ Serial #: ____________________
For your convenience,
place product registration
tear-off sticker here.
Purchase Date :_______________
Place of Purchase: ____________
Key Code: ___________________
• 1/2” deep well ratchet wrench
• 1/2” open or box end wrench
• 9/16” open or box end wrench
• Drill with 3/16”, 3/8” and 1/2” drill bit
• Carpenter’s square
Approximate installation time: 48 minutes (.8 hr.) depending on truck equipment installation experience.
(1) 5/16”-18 x 2-1/4” Black Oxide Hex
Head Bolt
(2) 5/16””-18 2-1/4” Hex Head
Bolt
(8) 5/16”-18 x 1-1/4” Hex Head Bolts
(2) Fender Washers
(1) 5/16”-18 Nylon Lock Nut
(2) Mounting Clamps
(1) “J” Bolt
5/16” x 2 1⁄4” Bolt.eps
"J"Bolt.eps
5/16” x 1 1⁄4” Bolt.eps
Read and understand all instructions and warnings before operating or using this product.
Danger of explosion. Do not use this product for storing or transporting flammables, explosives, hazardous materials, or hazardous waste, such
as containers of gasoline, solvents, gun powder, dynamite, propane tanks, acetylene tanks and cutting torches and gas-powered equipment. This
product is only intended and safe for use in storing and transporting small tools, equipment and other similar materials. Any modification made to or
unintended use of this product, could create a hazardous condition that can cause death, serious personal injury or property damage.
5/16” x 2 1⁄4” Bolt.eps
Mounting Clamp.eps
Part No. 24-0275 REV. B ECN 5305 04/13