Installing the corresponding receivers like i-m15a – AMC TR1A User Manual
Page 12
User manual-amc TR1a_G
Page 12 of 17
PN: 21-TR1a_IM
Installing the corresponding receivers like i-M15a
(here we use i-M15a for the installing procedures )
1. Turn on TR1a – power LED will be lighted
2. Turn i-M15a (or other corresponding receivers) battery power ON by
pressing the POWER (Battery Power) button on top of i-M15a for 5
seconds. Once i-M15a battery power turning ON i-M15a will be under
Standby mode. (If you have power adaptor plugged into i-M15a, the
i-M15a will be under Standby mode all the time.
3. Pressing ON/OFF button on top panel of i-M15a (or POWER button on
Remote Control handset) you will turn i-M15a from Standby(OFF) mode
to ON.
4. You will see Power on screen once turning i-M15a ON for the 1
st
time.
Then i-M15a will scan for all available TR1a and indicated on the screen
how many TR1a exist. (“ 0 or 1 or 2 or 3 or .... Transmitter Exist .
(Press ▲/▼)” )
Remarks : When you change locations of TR1a's or i-M15a's, you should
re-scan the TR1a by pressing RESCAN button on Remote Control
handset aiming at IR receiver located besides i-M15a LED's on bottom of
i-M15a front panel.
Scanning for TR1a takes around 25 ~ 40 seconds.
5. Press ▲ or ▼ button on top and bottom of “MENU” button, you will see a
list of available TR1a you can link your i-M15a to. The format of name of
each available TR1a is as following:
TR1-xxxxxx
(xxxxxx is IP address of each TR1a you can find on the Barcode label
on the bottom of each TR1a. It is the last 6 digits of the number under
the barcode)
6. Use ▲ or ▼ button on top and bottom of “MENU” button you can select
your preferable TR1a you want to view the programs from. You then
press ENTER on remote control to confirm and link to the TR1a you
selected.
7. You can start to enjoy programs from TR1a by using Remote Control
handset included with TR1a by selecting TV or AV1 or AV2 or S-Video
four sources from each TR1a.
8. If you want to select another TR1a for the i-M15a you are using, you can
press RESCAN button on Remote Control hand set and repeat above
procedure to make the choice.