White’s Electronics Coinmaster Pro - Manual (Page 3)

1) ON/OFF turns the Power ON and OFF. Low Battery indication is au-
tomatically shown on the display. Remove batteries for storage beyond
two weeks.
2) SENS (sensitivity) adjust the responsiveness to metals, ground, and
external electrical interference. Level shown on the display. Use the
highest level that behaves predictably, lower levels for areas unstable
(falsely signals without the presence of metal).
3) P/P activates pinpoint mode for better item location. Press a second
time prior to continued searching.
4) DISC (discrimination) selects the acceptance or rejection (regarding
audio beep) of each category on the display from IRON to C1 (zinc cent).
For more jewelry, except for iron, accept as much as you can endure.
5) The depth of coin-sized metal is automatically indicated on the lower
left-hand portion of the display.
6) Tone ID (tone identification). Press TONE ID. At minimum DISC,
three different tones now indicate the display categories, large iron, “Low
Tone”, foil & tab “Medium Tone”, all coins “High Tone”.
7) Smart Notch. Press Smart Notch. With Disc control set at FOIL or
below, pull tabs are eliminated. With Disc control at nickels or above,
nickels are accepted. Smart Notch either eliminates TAB, or accepts
nickels.
c
ontrols
D
isplAy
i
nDicAtions
•T
ypical
M
eTal
T
argeT
c
aTegories
•c
urrenT
M
eTal
i
ndicaTion
•d
isc
/r
ejecTion
•p/p (p
inpoinT
)
a
ll
M
eTal
M
ode
•c
urrenT
M
eTal
’
s
d
epTh
•l
ow
B
aTTery
i
ndicaTion
•c
urrenT
s
ensiTiviTy
s
eTTing
•T
one
i
denTificaTion
a
cTivaTed